Viking Catapult versus the Nidhogg Dragon
Set inventory
This set does not have numbered bags in the building instructions. The full set inventory is shown below without a per-bag split.
All bags
Sticker Sheet for Set 7017 - (54206/4277615)
Hinge Brick 1 x 2 Base
Hips and Blue Legs
Plate 1 x 2
Plate 1 x 4
Plate 2 x 3
Plate 4 x 4
Plate, Modified 1 x 1 with U Clip (Horizontal Grip)
Plate, Modified 2 x 2 with Pin Hole
Sports Minifigure Stand Soccer with Spring and Green Pin
Technic Ball Joint
Technic, Axle 2L Notched
Technic, Axle 6L
Technic, Axle 12L
Technic, Axle Connector 2 x 3 with Ball Joint Socket and Axle Socket with Molded Light Bluish Gray Rubber Insert Pattern
Technic, Brick 1 x 12 with Holes
Technic, Brick 4 x 6 Open Center
Technic, Disk 3 x 3
Technic, Liftarm Thin 1 x 3 - Axle Holes
Technic, Liftarm, Modified Bent Thick 1 x 9 (6 - 4)
Technic, Pin 3L with Friction Ridges
Technic, Pin Double with Axle Hole
Technic, Pin with Short Friction Ridges
Wheel 20 x 30 Technic
Technic, Axle 1L with Pin with Friction Ridges
Torso Viking Armor with 2 Shoulder Disks and Waist Disk Pattern / Sand Blue Arms / Yellow Hands
Bracket 1 x 2 - 2 x 2
Container, Treasure Chest Bottom with Slots in Back
Container, Treasure Chest Lid Curved with Thick Hinge
Plate 2 x 2
Plate, Modified 1 x 1 with Tooth Horizontal
Slope 30 1 x 1 x 2/3
Technic, Axle 3L with Stud
Technic, Brick 1 x 4 with Holes
Technic, Liftarm Thick 1 x 11
Technic, Liftarm Thick 1 x 9
Technic, Liftarm, Modified Ball Joint Angled 1 x 2
Tile 1 x 2
Torso Viking Silver Scale Mail Armor, Dark Orange Belt with Copper Buckle, Diagonal Strap Pattern / Light Bluish Gray Arms / Yellow Hands
Wedge 4 x 4 Triple with Stud Notches
Bionicle Ball Joint 4 x 4 x 2 90 degrees with 2 Ball Joint and Axle Hole
Bionicle Toa Nuva Leg Section
Dinosaur Tail / Neck Base Section with Black Technic Pin
Dinosaur Tail / Neck Middle Section with Bar Hole and Technic Pin
Dinosaur Tail End Section / Horn
Dragon Head Viking Beaked
Dragon Wing 19 x 11 with Bar Hole and 2 Pin Holes with Marbled Trans-Orange Trailing Edge Pattern
Hips and Black Legs
Plate 2 x 6
Plate, Modified 1 x 2 with 1 Stud without Groove (Jumper)
Plate, Modified 1 x 2 with Bar Handle on Side - Closed Ends
Slope 33 3 x 2
Slope, Curved 2 x 1 x 1 1/3 with Recessed Stud
Slope, Curved 2 x 2 x 2/3 with 2 Studs and Curved Sides
Technic, Axle and Pin Connector 2 x 5 with 2 Ball Joint Sockets, Open Sides
Technic, Axle and Pin Connector Perpendicular Double Split
Technic, Axle Connector 2 x 3 with Ball Joint Socket - Open Sides, Angled Forks with Closed Axle Holes
Technic, Brick 1 x 2 with Axle Hole
Bionicle Claw with Axle
Chain 21 Links (16-17L)
Minifigure, Head Balaclava with Silver Chain Mail, Yellow Face, Dark Orange Eyebrows and Goatee, Angry with Bared Teeth Pattern
Pneumatic T Piece Second Version (T Bar with Ball in Center)
Technic, Axle 5L
Technic, Brick 1 x 2 with Holes
Technic, Pin 3L with Friction Ridges and Stop Bush
Hose, Soft Axle 11L
Minifigure, Weapon Sword, Greatsword Angular
Brick, Modified 1 x 2 with Pin
Hinge Brick 1 x 2 Top Plate
Plate, Modified 1 x 1 with U Clip Thick (Vertical Grip)
Plate, Modified 2 x 3 with Hole
Plate, Round 2 x 2 with Rounded Bottom (Boat Stud)
Slope 30 1 x 1 x 2/3
Technic, Axle 2L Notched
Technic, Axle and Pin Connector 2 x 7 with 2 Ball Joint Sockets, Rounded Ends
Technic, Brick 1 x 4 with Holes
Technic, Brick 1 x 6 with Holes
Tile 2 x 2
Bar 6.6L with Stop Ring (Patio Umbrella Stand)
Brick 1 x 2
Plate 1 x 3
Plate 1 x 6
Plate 2 x 4
Plate 2 x 6
Plate, Round 2 x 2 with Axle Hole
Wedge, Plate 12 x 3 Left
Wedge, Plate 12 x 3 Right
Minifigure, Headgear Helmet Viking with Side Holes
Minifigure, Weapon Axe Head with Clip
Brick, Modified 1 x 4 with Studs on Side
Dish 4 x 4 Inverted (Radar) with Solid Stud with Viking Shield Red / Blue with Black Ornament Pattern
Plate 1 x 3
Plate, Modified 1 x 1 with Light Attachment - Thick Ring
Plate, Modified 1 x 2 with 1 Stud without Groove (Jumper)
Plate, Modified 2 x 3 with Hole
Wave Rounded Straight with Bar End and Small Pins (Castle Dragon Flame / Seaweed / Water)
Rock 1 x 1 Jewel 24 Facet
Barb / Claw / Horn / Tooth - Small
Dinosaur Tail End Section / Horn
Minifigure, Head Beard with Gray Hair, Moustache, and Angry Eyebrows Pattern
Frequently asked questions
-
This bag inventory was built by following the official LEGO building instructions step by step. At every step, we recorded which pieces were used and which numbered bag they came from, resulting in a complete parts list per bag.
-
Each numbered bag contains a specific subset of the set's total parts. By selecting a bag above, you can see every piece it includes — with part images, color details, and exact quantities.
-
Click on a bag, then use the export buttons in the toolbar. You can download a PDF for easy reference, or a BSX file — a BrickLink-compatible XML format you can import into tools like BrickStore.
-
We use bag 0 to list all parts that are outside of numbered bags, such as sticker sheets or some larger parts that are often not in any bag but directly in the box.
-
Since inventories are built by hand, mistakes can happen. If you spot anything wrong, please contact us so we can review and correct it.
Report an issue
Let us know what seems wrong with this bag inventory.
PDF format
Choose a layout for your PDF export.
Generating PDF
The inventory PDF for this bag is being generated. This may take a few seconds.