Isla De Muerta
Set inventory
This set does not have numbered bags in the building instructions. The full set inventory is shown below without a per-bag split.
All bags
Pirates of the Caribbean Poster - Isla De Muerta
Dish 2 x 2 Inverted (Radar)
Hips and Legs with Side Buttons and Red and Orange Vest and Sash Pattern
Minifigure, Hair Dreadlocks with Beads and Dark Red Bandana Pattern
Minifigure, Headgear Hat, Musketeer
Minifigure, Utensil Scabbard with Shoulder Strap
Torso PotC Topcoat with Red and Gold Vest and Dark Bluish Gray Belt Pattern / Black Arms / Light Nougat Hands
Turntable 4 x 4 Square Base, Locking
Plate 6 x 6
Technic, Brick 1 x 1 with Hole
Wedge, Plate 3 x 6 Cut Corners
Apple
Flag 4 x 1 Wave Right
Minifigure, Plume Feather Triple Compact / Flame / Water with Small Pin
Tile 1 x 1 with Gold and Tan Magic Compass with Thick Dark Red Needle Pattern
Torso PotC Vest Open over Shirt with Collar, Dark Brown Belt and Strap with Silver Buckles, Red and White Sash Pattern / White Arms / Light Nougat Hands
Brick, Modified 1 x 2 with Split U Clip Thick (Vertical Grip)
Minifigure, Weapon Sword, Cutlass / Saber with Small Hilt
Plate 1 x 2
Plate 6 x 6
Plate, Round Corner 3 x 3
Rock Panel 2 x 4 x 6
Slope 30 1 x 1 x 2/3
Slope 45 2 x 1
Slope 45 2 x 2
Slope 75 2 x 2 x 3 - Hollow Studs
Technic, Axle and Pin Connector Angled #1
Minifigure, Utensil Telescope
Slope 65 2 x 2 x 2 with Bottom Tube with Minifigure Dress / Skirt / Robe, White Panel with Black and Gold Trim Pattern
Torso Female Dress with Black Collar and Gold Trim over White Shirt, Medallion Pendant Necklace, Light Nougat Neck Pattern / Dark Red Arms / Light Nougat Hands
Plate 2 x 4
Plate, Modified 1 x 2 with Door Rail
Plate, Modified 2 x 2 with Groove and 1 Stud in Center (Jumper)
Plate, Round Corner 4 x 4
Technic, Axle 3L with Stud
Tile 1 x 2
Arch 1 x 5 x 4 - Continuous Bow
Brick 1 x 1
Brick, Modified 2 x 2 with Pin and Axle Hole
Brick, Round 2 x 2 with Axle Hole and Grille / Fluted Profile
Minifigure, Weapon Sword, Spike Flexible 3.5L with Bar End
Panel 1 x 1 x 1 Corner
Panel 1 x 2 x 1
Plate 1 x 10
Plate 2 x 6
Plate, Modified 1 x 1 with U Clip Thick (Vertical Grip)
Plate, Round 4 x 4 with Hole
Slope 30 1 x 2 x 2/3
Slope, Inverted 75 2 x 1 x 3
Technic, Axle 3L
Technic, Axle and Pin Connector Angled #2 - 180 degrees
Tile 2 x 4
Minifigure, Head Dual Sided Black Eyebrows, Moustache, Soul Patch and Goatee, Upper Eyelids, Dark Bluish Gray Eye Shadow, Cheek Lines, Lopsided Open Mouth Scowl / White Face and Smile with Teeth Pattern
Minifigure, Head Dual Sided Female PotC Elizabeth Light Brown Eyebrows and Dimple, Smile / Scared Pattern
Minifigure, Head PotC Hector Barbossa Ragged Brown Beard Pattern
Minifigure, Hair Long Wavy with Center Part
Rock 1 x 1 Crystal 5 Point
Minifigure, Utensil Coin Type 2 with 10 Mark
Minifigure, Utensil Goblet
Minifigure, Utensil Ingot 1 x 2
Plate, Modified 1 x 2 with 1 Stud without Groove (Jumper)
Plate, Round 1 x 1
Technic, Axle 2L Notched
Bar 6L with Stop Ring
Boat, 14 x 5 x 2 with Oarlocks and 2 Hollow Inside Studs
Cone 1 x 1 with Top Groove
Hips and Legs with Dark Blue Vest Tails and Red and White Sash Pattern
Minifigure, Utensil Oar / Paddle Reinforced
Slope, Inverted 45 2 x 1
Technic, Axle Connector 2L (Smooth with x Hole + Orientation)
Rock 1 x 1 Jewel 24 Facet
Minifigure, Plume Feather Triple Compact / Flame / Water with Small Pin
Brick, Round 1 x 1
Arm Skeleton, Bent with Clips at 90 degrees (Vertical Grip)
Leg Skeleton with Black Square Foot
Minifigure, Head Skull PotC Hector Barbossa Ragged Brown Beard, Teeth Pattern
Torso Skeleton, Angular Rib Cage
Technic Bush 1/2 Smooth
Frequently asked questions
-
This bag inventory was built by following the official LEGO building instructions step by step. At every step, we recorded which pieces were used and which numbered bag they came from, resulting in a complete parts list per bag.
-
Each numbered bag contains a specific subset of the set's total parts. By selecting a bag above, you can see every piece it includes — with part images, color details, and exact quantities.
-
Click on a bag, then use the export buttons in the toolbar. You can download a PDF for easy reference, or a BSX file — a BrickLink-compatible XML format you can import into tools like BrickStore.
-
We use bag 0 to list all parts that are outside of numbered bags, such as sticker sheets or some larger parts that are often not in any bag but directly in the box.
-
Since inventories are built by hand, mistakes can happen. If you spot anything wrong, please contact us so we can review and correct it.
Report an issue
Let us know what seems wrong with this bag inventory.
PDF format
Choose a layout for your PDF export.
Generating PDF
The inventory PDF for this bag is being generated. This may take a few seconds.